![]() ![]() ![]() The times are expressed in the 24-hour clock. To review any of the historical data is simply a case of adding the -s (start) and -e (end) options time to any of the usual sar commands. ![]() RELATED: What Are Read/Write Speeds, and Why Do They Matter? Historical Statistics With sar You can also use the -A (all) option to see a complete dump of everything sar can throw at you.Ĭheck out the sar man page for the full list. There are many more categories of information that you can select to review. bdscd/s: Total amount of data discarded in blocks per second.bwrtn/s: Total amount of data written to physical devices in blocks per second.The figure is given in blocks of 512 bytes, per second. bread/s: Total amount of data read from physical devices.dtps: Total number of discard requests per second issued to physical devices.wtps: Total number of write requests per second issued to physical devices.rtps: Total number of read requests per second issued to physical devices.tps: Total number of transfer requests per second that were made to physical devices.We’re asking for three sets of data with four seconds between them. To see the I/O and transfer rate statistics, use the -b (note, lowercase “b”) option. %vmeff: Calculated as pgsteal / pgscan, this is an indication of the efficiency of page reclaims.pgsteal/s: Number of pages the system has reclaimed from cache per second.pgscand/s: Number of pages scanned directly per second.pgscank/s: Number of pages scanned by the memory management system kswapd daemon per second.pgfree/s: Number of pages placed on the free list by the system per second.majflt/s: Number of major faults the system has made per second, that have required loading a memory page from disk.fault/s: Number of page faults, both minor and major, made by the system per second.pgpgout/s: Total number of kilobytes the system has paged out to the hard drive per second.pgpgin/s: Total number of kilobytes the system has paged in (retrieved) from the hard drive per second.The columns contain the following information. We’re going to ask for two sets of information, with five seconds between them. The -B (paging) option causes sar to display statistics related to the paging of memory to the hard drive. This command looks at three sets of data with one second between them, for core 1. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |